Product Information/Technical Data Sheet
Bonding of flexible PVC foils to one another, as well as to rigid PVC and other materials.
Standup paddle boards (SUP), inflatable boats, swimming pool liners, pond liners and vehicle tarpaulins made of soft PVC. For re-gluing and repair work, PVC pipes.
Processing instructions/product data
Viscosity (+23 °C) approx. 550 mPas
solids content approx. 27%
density 1.0 g/cm3
Colour colorless, transparent
wet bonding time Approx. 10 to 30 seconds (one-sided application) max. 1 minute (two-sided application)
order type one and both sides
processing temperature +15 °C to +25 °C
consumption 150 - 250 g/m2
cleaning Cured adhesive can only be removed mechanically.
Permissible storage time At least 3 years when stored in a cool and dry place in the closed original container.
Preferred storage temperature +10 °C to +25 °C
cold behavior Not sensitive to frost. thickening at lower temperatures. Fully usable after tempering to processing temperature.
•PVC-soft (PVC-P) ? Wooden materials
• Hard PVC (PVC-U) with each other and with ? textiles
•Artificial leather ? Paper, cardboard
Not suitable for: PE, PP, PTFE (Teflon®), POM, silicone, EPDM,
PS rigid foams (e.g. Styropor®)
Due to the large number of possible materials and differences in adhesion behavior, adhesion tests are necessary before practical use.
The surfaces to be glued must be clean, and in particular free of oil, grease or release agents.
The adhesive is applied on one side (small areas) or on both sides in a very thin, even and covering layer with a brush, spatula or roller. Absorbent, rough surfaces usually require a slightly heavier application or a second application after the first has dried.
Immediately after applying the adhesive, the substrates are joined together with light contact pressure. It must be ensured that the bonded materials remain in contact. If necessary, press again until a sufficient initial tack is reached and fix against slipping.
An assessment of the final strength and resistance can only be made after a few days!
Repairs to minor damage to swimming pool liners made of soft PVC can also be carried out under water. To do this, the appropriate PVC repair patch is coated with the adhesive and immediately pressed under water on the damaged area and rubbed in until the necessary initial adhesion is achieved. Air and water temperatures below +15 °C can lead to reduced bonding results!
|Product weight:||0,38 Kg|